Humidifier Analysis


Autoflo 200P Whole House Furnace Mount Humidifier


General Overview

Autoflo 200P Whole House Furnace Mount is a perfect choice for medium size homes. The Autoflo 200P Whole House Furnace Mount can perform better than any other comparable size power humidifier. Autoflo has patented “Convair-Cone” in the Autoflo 200P Whole House Furnace Mount due to which air flow is maximized through and around the evaporative media for increased capacity.


Manufacturer’s specifications

  • Weight: 12 lbs

  • Capacity: 14 gallons per day

  • Plenum opening: 8 inch diameter half circle

  • Plenum model: 16 inch width, 11 inch height, 9 inch depth

  • Electrical: 24 volts AC, 60 cycles, 3 watts


    Special Features

  • Easy access openings make cleaning simple

  • Stainless Steel construction resists corrosion

  • Adjustable float control

  • Replaceable urethane foam evaporator pad

  • Maximum installation versatility – take off can be either right or left hand


Warranty

All the parts of the Autoflo 200P Whole House Furnace Mount are offered a warranty of 1 year from the date of purchase written on the purchaser’s receipt regarding freedom from defects in material and workmanship. During the normal warranty period of the Autoflo 200P Whole House Furnace Mount, Autoflo would replace free of charge any warranted part that has been proved defective in workmanship or material under normal conditions of service, use and installation.


Pros

  • Very low energy consumption

  • Bacterial risk is minimized by non absorbing discs

  • Perfect choice for heat pump applications

  • Heating cycle and operation of Autoflo 200P Whole House Furnace Mount are independent of each other


    Cons

  • While starting the humidifier or controlling the humidity level, some of these humidifiers give a ‘click’ sound

  • After changing the filters of this humidifier, only the right hand bottle may drain into the humidifier

  • There is a water leak problem


Overall review

The design of the Autoflo 200P Whole House Furnace Mount is such that it is mounted on the side of a warm air plenum and the bypass duct is connected to the cold air return duct.

The best position in the Autoflo 200P Whole House Furnace Mount is locating the humidifier maximum close to the heating unit, downwards from the evaporator coil of the air conditioner system. The turns and offsets of the bypass duct are kept to a minimum so that it is as short as possible. The bypass duct should never be placed in the front side of the furnace.

In order to have correct furnace operation and servicing, all the furnace access doors and openings must be kept clear of any obstruction. While installation of the Autoflo 200P Whole House Furnace Mount is being done, all the connections must be placed outside the minimum clearance requirements for front, top, rear and flue of the furnace.

Back from Autoflo 200P Whole House Furnace Mount Humidifier to Autoflo Humidifiers

Back from Autoflo 200P Whole House Furnace Mount Humidifier to Humidifier Reviews - Home




Official Website





solar panel

daisy

grass

sun


sun

Share Your Review





Subscribe To
This Site

XML RSS
Add to Google
Add to My Yahoo!
Add to My MSN
Add to Newsgator
Subscribe with Bloglines

Enjoy This Site?
Then why not use the button below, to add us to your favorite bookmarking service?



Copyright© 2011 HumidifierAnalysis.com.
All rights reserved. No reproduction without permission.